Minimum width and spacing

Minimum width and spacing. DRC (Design Rule Check) measures every shape on a layer against the foundry's geometric rules. This metal layer breaks two of them, and you fix the geometry until it is clean:

• Minimum width, W_min = 0.10. A wire's width is its thickness, the narrow dimension. A wire thinner than W_min is a violation. Drag a wire's bottom edge to make it thicker.
• Minimum spacing, S_min = 0.10. Spacing is the gap between two separate shapes. A gap smaller than S_min is a violation. Drag a wire to move it and open the gap.

Each wire shows its thickness and each gap its size; a value at or above the minimum is legal (green), below it is a violation (red). Fix every violation, then Submit fixes. Dimensions in micrometres.